Linear iei keypad manual3/28/2024 This warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose. ![]() This keypad is not for use in extreme weather. Also, provide a weep hole at the bottom of the back box to prevent condensation from collecting on the circuit board. When mounting the 212w outside, use a weatherproof back box and apply silicone to the area where the wires enter the case. Use the included tie wrap to bundle all the wires together from the keypad wire harness and relay board. The relays must face up towards the keypad wire harness connector P2. If all 12 keypresses have been verified, the keypad will enter self test mode. 2.Connect the negative (-) lead of your power supply to the terminal strip (TS1) -V input. ![]() OTHER DOOR GARD PRODUCTS POWERGARD POWER SUPPLIES PG1224-3 12/24VDC 2.5 Amp Power Supply PG1224-3-C 12/24VDC 2. Connect the positive (+) lead of your power supply to the terminal strip (TS1) +V input. IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI recommends using a filtered and regulated power supply. 212iLW & 242iLW Standalone Keypad Installation & Programming Manual To install the relay board, plug the relay board onto P3 on the keypad. with indoor, weather resistant and Mullion keypad styles). IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God. (IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with. On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box.For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad.This allows air to circulate and a place for condensation to drain. Do not seal the drain holes at the bottom of the keypad housing.Do not silicone the cover plate because the unit will not seal properly. This helps prevent water from entering the case and condensing on the circuit board. Rugged, cast aluminum enclosure for indoor or outdoor mounting on a wall or pedestal. When mounting this unit outside, apply silicone to the area where the wires enter the case. The Model AK-11 Exterior Digital Keypad is a s elf-contained keyless entry system ideal for airports, hospitals, warehouses, office buildings, parking lots, and many other commercial facilities.The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |